1S 3.7V/4.20V LiPo Battery Charger Board for RC Drone Quadcopter with BT2.0/PH2.0 Connector

The charging channels of this charger are independent, so there is no need to worry about voltage variations between your batteries. This charger has low voltage protection (3.6V/cell safe ended voltage) to protect your input power (2S-6S) battery, avoiding over-discharge.

The 6-port 1S battery charger supports 1S 4.20V/3.7V LiPo and 4.35V/3.8V LiHV batteries. It has an input connector of 12V/2A DC55*25 or XT60, and an input voltage range of 7V-27V (2S-6S). The maximum charging current is 0.4A per port.

To use the charger, follow these steps: 1. Power the charger with a 12V power adapter or a 2S-6S battery. The display will first show "-3P" and then the input voltage. 2. Set the battery type switch to LiHV or LiPo, depending on your battery. 3. Press the button to set the 3-digit LED display to match your input power type, activating the low voltage protection to prevent over-discharge of your input power battery.

The discharge protection voltage is as follows: - 12V/2A adapter input: "-dc" - 2S battery input: "-2P", ending at 7.2V - 3S battery input: "-3P", ending at 10.8V - 4S battery input: "-4P", ending at 14.4V - 5S battery input: "-5P", ending at 18V - 6S battery input: "-6P", ending at 21.6V

1. After the display shows the correct input, wait 3 seconds without any action, and the setting is complete. The charger will then display the input voltage.
2. All 6 LEDs will start flashing, indicating that you can plug in your batteries. The charger will start charging automatically. Please do not use BT2.0 and PH2.0 connectors on the same channel simultaneously.

The charging status indicators are: - Standby without battery plugged in: Green flash - Charging: Green solid - Charge finished: Green off

If you need to adjust the input type during charging, simply press the button to change it again.

The package includes the 6-port 1S battery charger and a 12V (AC 110V-240V) US adapter. The HobbyFly 6-port 1S charger is designed for charging 1S LiPo batteries with BT2.0 and PH2.0 connectors, but please do not charge two batteries in one port at the same time to avoid reducing the battery life or causing damage.

product information: